Polski
English
Soft start for halogen lamps MST-01
MST-01 is used to reduce the starting current of halogen lamps. This prevents excessive use of connected lamps, resulting in prolonging their life.
On rail TH-35 mm.
On rail TH-35 mm.
Functioning:
At the moment of switching on the power supply, the controller does not allow immediate switching on of lighting to full power. Initially, the lamp system is powered by an internal thermistor limiting the current. After 1sec. the system switches on permanently contact, through which it transmits the full load of the receivers.
ATTENTION!
No effect of gradual illumination of lamps.
- Maximum AC-1 load current
- 8 A
- The executive element
- relay
- Contact configuration
- 1 × NO
- Output voltage OUT
- 230 V AC
- Switching time
- 1 s
- Input voltage IN
- 230 V AC
- Terminal
- pluggable terminal blocks 2,5 mm²
- Tightening torque
- 0,4 Nm
- Power consumption
- 0,1 W
- Working temperature
- -25 ÷ 50 °C
- Dimensions
- 1 module (18 mm)
- Assembly
- on rail 35 mm
- Ingress Protection Marking
- IP20
8 other products in the same category
MST-01 is used to reduce the starting current of halogen lamps. This prevents excessive use of connected lamps, resulting in prolonging their life.
On rail TH-35 mm.
On rail TH-35 mm.