Pulse power supply  ZI-24
search
  • Pulse power supply  ZI-24
  • Pulse power supply  ZI-24
  • Pulse power supply  ZI-24

Pulse power supply ZI-24

ZI-24, 5908312592297
Output voltage 24 V. Power 30 W.
The switched-mode power supply is used to supply electric and electronic devices that require a stable, filtered supply voltage independent of changes in the mains voltage.

Implementation

Type Output voltage
Output current
ZI-22 12V DC 2,5A
ZI-24 24V DC 1,25A

 

Attention!
* Below 160V input power supply voltage will continue to stabilize the output voltage, but the maximum output current will decrease concurrent with a decline in input voltage.
* Due to the high frequency converter, some very sensitive radio or microprocessor can operate correctly. It is recommended that you install the filter OP-230 (see item 18) between the power supply and receiver.
* By increasing the load above Imax will stabilize power supply current, but output voltage will decrease. If a outputvoltage falls to about 40% of the power supply is switched off and will be 1.5 ÷ 2sec. sample. Similarly happens when you connect the receiver, which receives a large current boot (ie the cold light bulb). If you're experiencing is not too large, the power supply after a few attempts (eg, the gradual warming-up, the light bulb filaments) runs. If the load is too large to sample the power supply will disconnect the load moment.

ZI-24
Type
impulse power supply
Power supply voltage
100÷264 V AC
Maximum load current
1,25 A
Output voltage OUT
24 V DC
Output power
30 W
Current limit
125% Iout
Minimal load
0%
Switching frequency
132 kHz
Mass
190 g
Terminal
pluggable terminal blocks 4,0 mm²
Tightening torque
0,5 Nm
Working temperature
10÷40°C
Dimensions
3 modules (52,5 mm)
Assembly
on rail 35 mm
Ingress Protection Marking
IP20